When your lawn lawn mower pull cord breaks , it can be frustrating , but reverence not ! replace the pull corduroy is a relatively simple-minded undertaking that you may do on your own with just a few tool and a spot of solitaire . In this comprehensive template , we will walk you through the steps to replace the pull cord on your lawn mower , so you’re able to get back to mowing your lawn in no time .
Gather Your Tools and Materials
Before you begin , verify you have all the necessary tools and cloth on manus . You will demand a pair of phonograph needle - nose pliers , a young pull corduroy , a screwdriver , and some scissors . Once you have everything you need , you ’re ready to come out the process .
Step 1: Locate the Old Pull Cord
To begin , locate the end of the old pull cord inside the starter trapping of your lawn mower . You may need to use acerate leaf - olfactory organ pliers to grab the cord if it ’s stuck . lento pull the quondam cord out of the housing , pass water sure to take away it completely .
Step 2: Remove the Rope from the Handle
Once you have removed the older corduroy from the housing , it ’s time to remove it from the grip . you’re able to do this by either cutting the knot or undo it , depending on how it ’s secured . Make certain to discard the old pull cord suitably .
Step 3: Feed the New Pull Cord
Now , take your new pull cord and course it from the exterior of the starter housing to the inside . Make trusted to thread it through any necessary guides or holes to ensure it ’s in good order aligned for reassembly . Once the cord is in place , you ’re ready to move on to the next gradation .
Step 4: Secure the New Pull Cord
With the new pull cord in position , it ’s time to secure it to the handle . Tie a knot at the end of the cord or apply the producer ’s commend method to check a dependable adhesion . clip any excess cord with scissors , leave just enough for a well-heeled grip .
Step 5: Reassemble the Starter Housing
Next , cautiously reassemble the starter lodging , making certain the pull cord is properly aligned and not tousle . employ a screwdriver to stiffen any piece of tail or bolts that hold the housing in place , control a snug fit that wo n’t come slack during use .
Step 6: Test the Pull Cord
Before you start the lawn mower engine , give the new pull cord a test take out to insure it ’s act correctly . You should feel resistance as you take out , and the cord should draw in smoothly back into the housing when turn . If everything checks out , you ’re just to go !
Caroline Bates
